Wheel Bearing Removal Alternative

[craigvg]

Here is my alternative way of removing those pesky wheel bearings. Follow the link. PM me if you prefer a higher res version or suggestions for improvement.

http://www.youtube.com/watch?v=SfUtDNMQ-Rg

[Agemax]

its a lot easier if you just slide a drift down through the middle, at an angle and tap one bearing out. flip the wheel over and tap the other bearing out. no cutting involved.
10 minutes and job done

[craigvg]

After nearly ruining my swingarm via attempting to remove the needle bearings. My abilities to use a drift properly were questioned......amongst many other things. Thanks for the response Agemax

[Agemax]

After nearly ruining my swingarm via attempting to remove the needle bearings. My abilities to use a drift properly were questioned......amongst many other things. Thanks for the response Agemax

admittedly swing arm needle bearings can be trickier than wheel bearings, but they are both really simple jobs. stick with the method that suits you best.

welcome to the site by the way

[salty_monk]

I use one of these... http://pitposse.com/whbereset.html

You can do approx the same thing with one of these:

[WilliamGLX81]

I used one of those expanding bolts on ...front wheel bearings I think. Beat on that thing like you would not believe, and finally used a drift successfully. I think the expanding bolt did work, but it was not easy.

[salty_monk]

That's why I use one of these I use one of these... http://pitposse.com/whbereset.html

30 seconds or less per bearing...