OK, so my rear calipers have been cleaned, new piston boots etc. When I went to bleed them oil is coming out somewhere. Does not seem to be boots. But just above one of the two main bolt holed there is another passage way on the cover and main body. Is there supposed to be some kind of washer that goes there ? I believe that is where oil is seeping out. Project bike form hell is slowly coming along. Thanks
-
-
Did you replace the seal between the two caliper halves?Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection -
You mean seal for that passage way above the bolt hole about 3/8 diameter. I just now ordered on part number 5 looks like a washer of some sort. Inner bores have new seals.Comment
-
Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
Comment