E
edmondsm
Guest
I have gotten the honda six wire R/R from Mr. Duaneage, I understand I need to connect the three yellow wires to the stator (no problem). I understand I connect the Green wire to the battery negative. The black wire is the sensing wire that goes to the rear light switch, where might I find this? Also, what is the black striped in white wire that was on the original R/R for? Do I need it? I have been looking for a colored diagram that shows where this goes, but have found none showing a black/white wire. So basically I need to know where to connect the black R/R wire and what to do with the black/white harness wire?
Thanks
Funny thing is the shop I had the bike in (full time student, husband and father with no time) told me the stator was bad because it was putting out around 86 Volts per leg, I am assuming it to be good becasue the manual says it is supposed to put out above 80V. They also could not figure out how to wire up this stator with the supplied diagram from Mr. Duaneage
Thanks
Funny thing is the shop I had the bike in (full time student, husband and father with no time) told me the stator was bad because it was putting out around 86 Volts per leg, I am assuming it to be good becasue the manual says it is supposed to put out above 80V. They also could not figure out how to wire up this stator with the supplied diagram from Mr. Duaneage