?80 GS1100L Front Brake Reservoir - wrong part issue

[Guest]

I just recently purchased a 1980 GS1100L. PO had informed me of a leaking front brake fluid reservoir (I think it was dropped on that side). Said he had ?superglued? it for a temp fix, but is is leaking slightly.

He and I both have ordered new replacements, according to the correct diagram on the parts schematics. UNfortunately the holes for the Phillips screws don?t line up. My original has holes that are 180 degrees apart towards th perimeter on the inside, where as the replacement that I?ve received has the screw holes side by side, just off center.

Any suggestions as to how to obtain the right one (I checked two different sites...same part number, same parts diagram for a 1980 GS1100L ). Thanks!

 

[Guest]

I have an 80-L and recently had mine apart and don?t remember for sure but seems like I only had one screw holding mine in place but I?ll check this evening

 

[Guest]

Thanks. I’ve sent the vendor pics of the differences. They are going to try and sort it out (hopefully!)

 

[Steve]

Was the PO the only owner the bike has ever had? :-k

Probably not, and there is no telling what someone might have put on there some time in the last 38 years.

It might not even be a Suzuki item. :-\\\

.

 

[Guest]

Checked mine this morning and I have the 2 holes side by side and I just assumed that those holes were for letting the brake fluid pass in/out to the master cylinder.....my holes don't line up either and I just have one screw in the center....I've owned my L since new and don't recall ever pulling the res apart.