• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

81 GS1100E breaking up after 2800 RPM

  • Thread starter Thread starter drewandkellie
  • Start date Start date
D

drewandkellie

Guest
I am restoring an 81 GS1100E . I fixed the starter clutch with your help and am almost home. It is basically stock except for a Vance and Hines 4 into one(and of course the airbox was missing so the back of the carbs are open). The carbs looked suspicious so I swapped them with the good running ones (with stock jetting)off my other 1100E. The bike starts right up and idles smoothly. It pulls well at small throttle openings but breaks up at about 2800 RPM. If you twist the throttle open any more than about a 1/4 throttle it dies and bogs down to absolutely nothing. It is doing the same thing with both sets of carbs so I think I elimiated the chance of it being the carbs. (the good carbs run perfect on my other 1100E). All the exhaust pipes feel hot so I know all the cyclinders are operating. What could cause this midrange and upper end fall out? Seems fine under 2000rpm. Is it an airbox issue? Could it be electrical? I appreciate any ideas.

Thanks
Drew
 
Drew,

It is quite likely an airbox issue. These bikes flow way too much air without the airbox and will hardly run at all without one.

Joe
 
Thanks Joe. I'll throw my airbox on it and post what happens
 
Well it was the airbox! Put the old carbs (47.5 pilots[1 size over] 112.5 mains[2 sizes over])on and it runs pretty well. Pulls like a crazed animal above 3000 RPM. Only lingering problem is a roughness when riding at 3000 RPM.
Thanks for the help Joe.

Drew
 
On my 1100 when I ran an airbox and 4-1 pipe I used 117.5 mains. 47.5 pilot jets. One up on the pilot air jet. I ran with the airbox lid off. Pull out those idle mixture screws and make sure the o-rings are good. With the 47.5 pilot jets you'll need to adjust them for a good idle. 3000 is too high. Have you tried adjusting your idle knob or do you have cracked intake pipes or serious airbox leaks at the rubber boots.
 
Back
Top