• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

Fork Pin?

  • Thread starter Thread starter wheressinatra
  • Start date Start date
ROFLAO!
SORRY :oops: that is the hole you stick a / the phillips screw driver in to hold axle while removing the nut from the front axle, it keeps the axle from spinning when taking front wheel off.
 
That hole is there for your convenience when you pull the axle.
Insert a Phillips screwdriver, and you can twist and pull to get the axle out easier. \\:D/
Of course, that is after you loosen the nut on the other end and remove the caliper(s) to allow the wheel to fit through.


.
 
I have also seen racing bikes put a 'safety wire' through that hole just in case.

Some race clubs insist that every nut, bolt etc is 'safety wired' into place.
 
You must log in or register to reply here.
Back
Top