Turn Signal Piece

[lukehan]

Hi,
Ever since I bought my 79'gs850 it has had a vetter hard luggage rack on it. I decided recently to take it off and put it back to stock. I have almost everything I need, but I am missing two little pieces that I am not sure where to find, I can probably make some, but I figured I would check with you guys first. In the picture below it is what fits around the mounting bolt that comes out of the turn signal body, I am guessing it is a little hard plastic piece with a round base and a square body that fits into the rubber mounting piece #18. It is what keeps the turn signal from rotating. Any ideas where to find a couple of these?

thanks

Luke (sorry for the extremely long link)

http://houseofmotorcycles.bikebandi...el_dept_id~987836~model_dept_name~GS850GN.asp

 

[FTGRET]

The bracket is stamped steel. Put a post in the parts wanted or find someone who is parting out a bike. Worst case, buy them new.

 

[lukehan]

I already have #23&24 in the picture, what I need does not have a number.

Luke

 

[beby99]

I believe the part you are talking about is glued/molded to the turn
signal. You would have to get the whole signal...check ebay.

 

[mixongw]

I replaced my broken turn signals recently. I think I may have what you need. I'll get back to you.

 

[Clone]

What are you going to do with the bags? :wink:

 

[lukehan]

I'm keeping them, I just like the look of my bike better stock and I'll put them back on for long trips, but I have a tank bag for short trips. I do have a complete front fairing/windshield for a 79' gs850 that I don't want anymore, it even has an air horn.

Luke