• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

Yet another carb question

  • Thread starter Thread starter indyjoel
  • Start date Start date
I

indyjoel

Guest
Ok, cleaned the carbs (yes extra clean dipped, 24 hours), replaced o rings, bench synced.

Put them on brand new inlet rings that we nice and soft with new orings.

Bench synced and the screws are out to three turns.

Go to start and it makes a sound like it is sucking in air around the carbs.

Any idea?
 
Check all the places where the engine pulls vacuum...

- Nipple on carb #2 inlet where petcock vacuum line attaches (check hose too)

- look to see all the inlet boots are actually attached correctly to the carbs - sometimes the rubber folds over on the bottom when you push the rack on.

- Are the holes plugged where the sync adapters screw into the inlet boots for carb sync's ?

- Spray some carb cleaner around the boots & carbs when it's running & try to isolate where it's sucking air.

good luck...
 
You must log in or register to reply here.
Back
Top