Mikuni BS/CV Kits Includes
- 4 Pilot Screw O-rings
- 4 Float Valve O-rings
- 4 Choke Plunger Cap O-rings
- 12 Transfer Tube and Vent Tee O-rings
- 4 Drain Screw O-rings
These kits are for the common BS32/34/36 four cylinder bike sets. I don't have experience with the 450 sets or the two barrel 2nd gen 550 carbs. Sorry.
Mikuni VM Kits Include
- 4 Pilot Fuel Screw O-rings
- 4 Pilot Air Screw O-rings
- 4 Choke Plunger Cap O-rings
- 12 Fuel Tee/Transfer Tube O-rings. You may not need these, if your set has rubber coated parts, but I include them just in case.
- 4 Drain Screw O-rings
- 4 Needle Jet O-rings
All O-rings are Nitrile/Buna-N. These O-rings will swell slightly with gasoline contact, which helps improve the seal.
Cost is $20 shipped CONTUS per set. Paypal, cash in an envelope, check, all accepted. International shipping on a case by case basis, but typically just a dollar more. Send me a PM if interested, and I'll provide paypal info, or contact me at nessism _ AT sbc_global dot net (remove spaces and underlines)
Thanks for looking
EDIT 7/22/2025
For the VM guys, those with rubber coated fuel inlet Tee and Transfer tubes, If the rubber is shrunk and won't seal inside the carb body, a reasonable fix is to chop off a section of the rubber on the tee, and slide on a couple of O-rings per side. Polish the metal after removing any rubber, to assure no ridges are present on the metal portion of the Tee, and needless to say, test well before putting into service.

Comment