yet another newb question but curious...

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • frankenfab

    #1

    yet another newb question but curious...

    Ok.. rode the 750 (77') last night/day. Was stopped on the way home and once on the side stand a bunch of oil/**** dumped out of the side cover.

    Pulled the side cover assuming that the primary drive seal was toast. Found a ton of old dirt and oil (an impressive amount) and cleaned it up. Ran the bike and could not find any leaky seals. My thought at this point is that there was a lot of BS collecting under the cover due to all the dirt and it dumped out making me think that there was a bad seal... whatever. Figured I would clean it up and ride it then see if it leaked anywhere.

    Ok.. so.. all buttoned up. Bike in gear... Rev the crap out of it and nothing. Nothing.
    No stalling and no forward motion.
    WTF?
    Uninstalled and reinstalled the cover a couple times. Slacked the clutch cable completely on the last try and still had nothing.

    Anyone have any thoughts?
  • blowerbike
    Forum Guru
    GSResource Superstar
    • Aug 2008
    • 7057
    • Ohio Closer to KY Than Cleveland

    #2
    worm gear worm gear worm gear

    Comment

    • frankenfab

      #3
      couple of the shims were out (rubber seal shims) causing the clutch mechanism to be fully engaged. = retard.

      Comment

      • frankenfab

        #4
        (meaning I am a retard)

        Comment

        • Guest

          #5
          On the leak check the starter o-ring and see if the cam chain tensioner is leaking.
          All this drains into the starter cavity and out a hole by the stator cover.

          Comment

          • blowerbike
            Forum Guru
            GSResource Superstar
            • Aug 2008
            • 7057
            • Ohio Closer to KY Than Cleveland

            #6
            Originally posted by frankenfab
            (meaning I am a retard)
            10-4
            it happens sometimes.

            Comment

            • frankenfab

              #7
              Pretty sure that it's the starter o ring.. still only happening erratically.... have a complete oil seal kit on the way so will be fine.

              Comment

              Working...