Pulled the side cover assuming that the primary drive seal was toast. Found a ton of old dirt and oil (an impressive amount) and cleaned it up. Ran the bike and could not find any leaky seals. My thought at this point is that there was a lot of BS collecting under the cover due to all the dirt and it dumped out making me think that there was a bad seal... whatever. Figured I would clean it up and ride it then see if it leaked anywhere.
Ok.. so.. all buttoned up. Bike in gear... Rev the crap out of it and nothing. Nothing.
No stalling and no forward motion.
WTF?
Uninstalled and reinstalled the cover a couple times. Slacked the clutch cable completely on the last try and still had nothing.
Anyone have any thoughts?
Comment