You think your 750 would be better with...

[makenzie71]

Thanks Pankake.

[mike-s]

Holy carp, I can't believe i managed to miss this thread totally until now.

Nice job.

[7981GS]

What are your plans for the intake manifolds?

Daniel

[makenzie71]

I believe I have done what I will do with the intake manifolds...I put my carburetors and pods on them.

[7981GS]

So it runs just fine with the float bowls at that terrible angle?
How high/low did you have to set the float levels and how does that make them run?

Daniel

[makenzie71]

If by "runs just fine at that terrible angle" you mean "runs a 10.51 with a good launch, still gets 48mpg, and starts right up" then yes, runs fine.

Floats are set to factory levels. The angle isn't so aggressive as it seems to be. I imagine it isn't ideal, and it is tilted a little more forward than it was in the Kat chassis, but not anymore than it would be had someone slapped GSXR forks on the Kat.

[Guest]

I run a set of 34mm carbs from an '87 gsxr 1100 on my '83 750. I had to lower the float level to compensate for the lesser angle they now have.

[makenzie71]

I might take that to mean I should have made some adjustments of my own if they were the same carburetors, same motor, or the same bike.