Hey guys I think I already know the answer to this but... is this normal?
-
-
to kind of add some detail to the picture, the teeth are really thin on most and than thick right at the end of the tooth. Kind of like a wedge. I have a feeling I need a new one. Anyone know where to find one? -
That one is pretty bad. Did it move at all?
I probably have one if no one else wants to help.
Where are you located and which model G?
EricComment
-
That final drive looks done for. Some Honda Moly 60 grease would have helped.
Ebay has tons of final drive units for cheap. All the 850/1000/1100 units are the same other than the '83+ 1100 units have a taller ratio.
Good luckEd
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
go figure Ness. Its out of a 1984 GS1100 GK... So am I not able to use an older final? And yah it still moved. I only took it out for a ride around the block last year before I started to tear it apart.Comment
-
Yes, you can use an older unit, including one from an 850.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
ok cool. Just be a bit of a higher RPM at cruise I take it eh. Atleast the spline is in not bad condition.Comment
Comment