Stock 750, stock jets, etc. What would be a good starting point for these screws? I seem to remember reading somewhere about one complete turn out? Sound about right? These are the fuel screws, not the air screws, to be clear.
-
-
3/4 to 7/8 of one turn. When turning them in, to seat, be very careful that you don't bottom them hard, and break off the tips in the carb body.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection -
Thanks Ed. I checked them, all good in that regard.Comment
Comment