Announcement

Collapse
No announcement yet.

750 Mikuni mixture screw starting point

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    750 Mikuni mixture screw starting point

    Stock 750, stock jets, etc. What would be a good starting point for these screws? I seem to remember reading somewhere about one complete turn out? Sound about right? These are the fuel screws, not the air screws, to be clear.

    #2
    3/4 to 7/8 of one turn. When turning them in, to seat, be very careful that you don't bottom them hard, and break off the tips in the carb body.
    Ed

    To measure is to know.

    Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182

    Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846

    Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf

    KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection

    Comment


      #3
      Thanks Ed. I checked them, all good in that regard.

      Comment

      Working...
      X