VM 29 jet kits

[rputney01]

I've seen references to a stage 3 dj kit for the 29mm smoothbores on the forum, but it isn't referenced on their site that I can find. Is it same kit as the 26mm stock carbs?

Thanks.

[tkent02]

Similar question, may be helpful, not trying to jack your thread...

Stock GS 1000 E engine, V&H pipe and K&N pods, jetted very nicely for the elevations where I ride. How will my jetting requirements change when using VM 29s?

I know I will have to fine tune but looking for a ballpark to start with.

[Nessism]

Look at this information, there is suggested starting points for jetting...

[rputney01]

Similar question, may be helpful, not trying to jack your thread...

Stock GS 1000 E engine, V&H pipe and K&N pods, jetted very nicely for the elevations where I ride. How will my jetting requirements change when using VM 29s?

I know I will have to fine tune but looking for a ballpark to start with.

I'm currently jetted at a 122.5 main and a 22.5 pilot on my vm 29's. I took a long time to get it dialed in, particularly at idle. It is running pretty strong right now.

[first timer]

dig through this thread, there should be some base line 29mm info for you. if not do a search I know there are several threads about 29mm jetting on a stock 1000 motor