Pilot screw...... is out for lean or rich ???
-
-
What carb? VM or CV?
CV out is richening. -
Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
I know on my 82 GS650g (CV carbs), Clock-wise is lean, and counter is rich.
I start at 2 or 2 1/2 turns out from bottom.
Damn things are touchy too, i cranked them a tad too rich last week and nearly fouled out my plugs.Comment
-
Pilot screw ??
81 gs 1000g
Note sure what carbs
after repacking and putting new ends on my mufflers I fing the plugs are sooting up so I thought I would lean the mixture up by adjusting the screws on top of the carbs that I think are the air pitot screws.
Am I on the right track or have I lost it.Comment
-
What exactly did you repack?Comment
-
Pilot screw
My old megahones had nothing inside and the end caps had rusted away so I got some aluminium tube drilled some holes in it and wrapped some fiberglass wrap around it and stuck it in the empty megaphone , I the got some aluminium and cut it in to fit the the ends and drilled some holes in it, still pretty loud though,
so now I guess to air flow is restricted and my plugs are sooting up.
I thought I could adjust the air srew on top of the carns to lean the mixture out a bit.Comment
-
that'll sort out the bottom end but what about the mid and top end?... likes been mentioned, open up the carbs and see what jetting / settings are inside. chances are needle and main had been changed for the less restrictive pipe and this will need changing back towards where it was originallyComment
Comment