Starter screw stuck.

[radek22]

I hope you are doing this outside.
PB Blaster stinks and heated PB Blaster reeks.

Definitely, hope to resolve it without the heat though, I'll give it another day or two of PB treatment.

[steve murdoch]

Any luck with the unwilling bolt?

[Brendan W]

Is the other screw out?
Don't ask why but it might be worth putting it back and tightening it.

[radek22]

Any luck with the unwilling bolt?

Not yet, just back from vacation, and back at it. Still putting a bit of PB Blaster on the screw top, but patience is running thin Going to try the torch soon. Worst case scenario, Fortnine has them new for $250 Canadian.

[radek22]

Is the other screw out?
Don't ask why but it might be worth putting it back and tightening it.

I did try to move it both ways, steady still so far

[Gorminrider]

impact driver can help. They can be adapted down to take a small socket if you can fit a small socket to the bolt...If you break or cut the long bolt, replacements can be found or you can make your own-thread some rod.

[radek22]

impact driver can help. They can be adapted down to take a small socket if you can fit a small socket to the bolt...If you break or cut the long bolt, replacements can be found or you can make your own-thread some rod.

Going to try to fit a small socket over the screw, thanks for the tip!

[radek22]

impact driver can help. They can be adapted down to take a small socket if you can fit a small socket to the bolt...If you break or cut the long bolt, replacements can be found or you can make your own-thread some rod.

Cheers Gorminrider, bit of hammering of the socket over screw top and it worked, thanks again!