Help no spark!!!

[80GS750]

ok, i need some highly technical info here....

here is my rough drawing....



ok, i have no spark on 1&4. just put a new coil in. both coils are good.
wire B has good voltage from the battery, wire A shows continuity between the coil and the box. on the other hand, wire C shows NO continuity. this does not make sense to me cause 2&3 have spark just fine but no continuity and 1&4 have no spark but have continuity. i am lost here. what are the white and the black wire for?

note, the black wire also has a stripe, i think its white but i dont remember now.

[80GS750]

as of right now i think its the ignitor box. is there any way i can sub the black wire from the ignitor for the white one on the first coil? just to see if i can get spark?

i looked and ignitor boxes are expensive!!! crap

[SqDancerLynn1]

It won't run but switch A & C. Most people switch to the Dyna Ign when the stocker gives out

[80GS750]

it did run on 2 cylinders, but i obviously wont let it stay that way. so i can swap a and c just to verify thats the problem?

[80GS750]

whats the best place to get a dyna ign? on ebay they are like 130... is that a good price?

[Guest]

This guy has been selling used ones. I don't know if they're good but I've seen him sell at least ten and his feedback is good.

http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&ih=009&sspagename=STRK%3AMEWA%3AIT&viewitem=&item=190115582128&rd=1,1

[80GS750]

sweet man. i sent him a question to see if it will fit on mine or not.... i know i need the dyna 3-2.

[Guest]

www.Z1enterprises.com has 'em for new for 120.00

Good luck. Just replaced my CDI/igniter this week. Coils are next.