Adjusting the float height?

[NitroGS]

Hi Guys,

Just checking what tool you guys use to adjust the float tabs to change the float heights please

[twerth]

I use a cheap micrometer to check height and a flat blade screwdriver to bend the tabs.

[bwringer]

I use a cheap micrometer to check height and a flat blade screwdriver to bend the tabs.

I use cheap plastic calipers that I can lock at the correct height. I use the depth measuring part.

Sometimes I need something a little more pointy to get in there and bend the tab, so I use a jeweler's screwdriver. Usually, I just use a small flat blade.

Make sure both sides of the float are at the same height, too...

[NitroGS]

Many thanks guys, very helpful