Any suggestions?
GS Oil Pressure Tester 0-25 PSI
Collapse
X
-
GS Oil Pressure Tester 0-25 PSI
Some of you may know I developed a knock @ idle in my GS1000 after performing plug chops. I would like to rule out the oil pump output but I have I don't have a oil pressure gage/tester in my box of tools. I just want to measure the output pressure but and not necessarily install a permanent gage
Any suggestions?Steve
1979 GS1000E (45 Yrs), 1981 GPz550 (11 Yrs)Tags: None -
Installed a gauge on my 850 by drilling and taping the plug on the side of the cylinder (plug is same as the fill plug for the diff). Simple matter to connect a gauge after that.
Automotive fuel system gauges are low pressure (0 - 15 psi), and "should" tolerate oil reasonably well. I think Jeg's and Summit sell gauges for less than $20 so you might want to consider this.
http://www.jegs.com/webapp/wcs/store...5085%3A1147708
Good luck.Last edited by Nessism; 06-18-2008, 09:12 AM.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-Resurrection -
Nessism,
I am kinda looking for a oil pressure tester which would be similar to a Compression or Vacuum Tester, any suggestions? BTW I am always amazed with your ability to locate anything GS related from feeler gages on up. If you run across a 1978 -1982 Ducati 900 or BMW R90S let me, LOL.
ThanksSteve
1979 GS1000E (45 Yrs), 1981 GPz550 (11 Yrs)Comment
-
Path of least resistance is as I already described. Total cost will be about $25. An oil pressure tester will have too high a range to read the low GS oil pressure.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
Comment