can i dremel the engine and the air cooling blades with the wire brush attachement. will this cause any damage to the air cooling blades?
-
-
Yes, you can
No,it won't hurt anything but paint1978 GS 1000 (since new)
1979 GS 1000 (The Fridge, superbike replica project)
1978 GS 1000 (parts)
1981 GS 850 (anyone want a project?)
1981 GPZ 550 (backroad screamer)
1970 450 Mk IIID (THUMP!)
2007 DRz 400S
1999 ATK 490ES
1994 DR 350SES -
You'll go through an awful lot of those expensive little brushes, but it won't hurt the engine.1983 GS850G, Cosmos Blue.
2005 KLR685, Aztec Pink - Turd II.3, the ReReReTurdening
2015 Yamaha FJ-09, Magma Red Power Corrupts...
Eat more venison.
Please provide details. The GSR Hive Mind is nearly omniscient, but not yet clairvoyant.
Celeriter equita, converteque saepe.
SUPPORT THIS SITE! DONATE TODAY!
Co-host of "The Riding Obsession" sport-touring motorcycling podcast at tro.bike!Comment
-
Sanding Cooling Fins
If you are trying to clean off the ends of the cooling fins on a black motor, Just use a small electric sander. You can use a Dremel with a sanding drum attachment for the hard to reach spots.Comment
Comment