Do I just need to replace the throttle tubing if it is real tight? When I turn the throttle its not that smooth. its pretty hard to pull back. doesn't give it the gas it should. Anyway to loosen that up or am I stuck like that?
-
Last edited by Guest; 05-23-2009, 03:27 PM. -
Take the cables off Clean & lube them should fix your problem. Make sure the grip is not pushed up too far -
Check the bends.
Check the bends in the cable, tight bends make for a tight throttle.
Check if the grip is rubbing on the handlebar.
It might be the price of gas too.
1982 GS1100G-
1990 GSX750/1127
1987 Honda CBR600F Hurricane
1985 Kawasaki GPz750Comment
-
If it's a dual cable throttle make sure the cables are not too tight ie. you need a bit a slack in both cables. I found my return cable was quite snug and it was causing the carbs to stay open when I released the throttle at high revs, as well as being hard & rough to twist - at first i thought it was the carb spring.Comment
-
Make sure you don't have the throttle jammed into the end of the handlebar.Comment
Comment