Where do I get this bulb?

[dpep]

The one on the left. On the right is the standard double filament running light/turnsignal bulb for just about any UJM. The one I can't find is essentially the same bulb with a smaller dome component to fit into a smaller housing.



It fits into this iddy biddy turn signal that was on my 1100E when I bought it. I will be replacing it with stock, but in the meantime I just wanted to replace the burned out bulb and have a functioning left turn signal again.



I have checked Auto Zone, O'Reilly's, Advanced, PepBoys, and Wal Mart. I have also been unsuccessful finding the bulb or the turn signal on Google searches. It is two filament, two contacts on the bottom, and offset retention nipples on the side. It doesn't have a hint of a part number on it; I have been over it with a magnifying glass. The only markings are 12v23/8W.



It's got me whipped.

[Larry D]

Trying to find one for you Don......do you know what kind of itty bitty turn signals they are ?

Lockhart, perhaps ?

[Larry D]

From across the pond.......

http://www.carrotcycles.co.uk/cycle-engine-parts/bulbs/12v-bulbs/stop/tail-small-globe-12v-23/8w-ba15d-lucas-/prod_817.html

[marvinsc]

Don, check out P/N 54109293 If these Guys don't have it, it's gonna be hard to find.


http://www1.mscdirect.com/CGI/NNPDFF...9293&PMCTLG=00

[Larry D]

Or #41 on this page. About halfway down the page......kinda hard to tell if it's the exact one.

http://www.4strokesonly.com/electrical.html

[rustybronco]

the #41 bulb lists as small globe 1157 which is a double filament double base (aka #198)

are the side pins on your bulb at the same level or at different heights? the #1157 is at different heights.

[bwringer]

They're those weirdo bulbs found only in cheapo Lockhart-Phillips turn signals.

I found it easier and faster to buy a new set of turn signals than to track down a replacement. Seriously.

[Larry D]

the #41 bulb lists as small globe 1157 which is a double filament double base (aka #198)

are the side pins on your bulb at the same level or at different heights? the #1157 is at different heights.

Don mentioned in his original post that the bulb had offset retention nipples.......which is almost obscene.

[rustybronco]

Then a #41 or #198 bulb it should be.

[Jakob]

Probably not any help but I searched probably as much as you have. The only ones I could find like that were all single filament. Good luck though.

The single filaments are here:

http://www.powersportsrider.com/web/sub/BM0409C0055Z.HTM

Bottom of page, part #26-8037 for clear.

~~>Jakob

[gtsg01]

Dennis Kirk has them

I have the same signals on my bike, and these bulbs fit.


http://www.denniskirk.com/jsp/produc...fCatId=&mmyId=