Required reading for all forum users!!!
Welcome!
Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.
A note to new registrants...
All new forum registrations must be activated via email before you have full access to the forum.
A Special Note about Email accounts!
DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.
A note to old forum members...
I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.
Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.
Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...
) I had carefully torqued everthing every thread had been cleaned and was easily able to be run in and out by hand etc. I was fantastically pleased 
, I lifted the motor into the chassis (by myself 8O ) installed the sump, installed the rocker cover, carefully torqued all the engine mounts, fitted the carbs;having cleaned and manually synched them, the ignition, cleaned and checked every electrical connection, carefully routed all the wiring, zip tied it all neatly and mostly hidden. Thought to myself, Hmm just one final check before I fire her up!!!!(insert twilight zone music here 
) I removed the ignition cover put a 19mm socket on it and slowly turned the motor over, I got two-thirds of the way to a full revolution and the motor locked up!!!! (insert primal scream) It had taken an entire weekend to get to that point ( I started with the motor assembled on my bench) My wife and children scuttled away in fear of there lives!!! 8O . I had the motor out and back on the bench dis-assembeled in half an hour!!!! Without removing the sump the breather or rocker cover!!! I have no idea how!!! 8O the motor WILL NOT fit in or out with out removing at least the breather cover!!! I know I tried to get it back in with it fully assembled and it will not go into the frame.
Comment