Mark
Degree Wheel Details?
Collapse
X
-
Anonymous
Degree Wheel Details?
I have downloaded the degree wheel pdf from this site and will be gluing it onto some sheet aluminum for a backing. Question is, what size hole do I need to put in the centre (for my 82 1100E, of course) and what size/thread of nut do I need to install it on the end of the crankshaft?
MarkTags: None -
My Motion Pro degree wheel has a .235 inch or 6mm hole. I took off the ignition cover and used the small bolt on the outside to hold the degree wheel. I use a thin spanner wrench to reach the larger bolt behind it to turn the motor.1982 GS1000S Katana
1982 GS1100E -
Anonymous
Bolt your degree wheel to a electonic trigger off a GS1150(than you can turn it and watch it without a chance of moving). DaveComment
Comment