Degree Wheel Details?

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • Anonymous

    #1

    Degree Wheel Details?

    I have downloaded the degree wheel pdf from this site and will be gluing it onto some sheet aluminum for a backing. Question is, what size hole do I need to put in the centre (for my 82 1100E, of course) and what size/thread of nut do I need to install it on the end of the crankshaft?


    Mark
  • pano
    Forum Sage
    GSResource Superstar
    Past Site Supporter
    • Apr 2003
    • 1818
    • MA

    #2
    My Motion Pro degree wheel has a .235 inch or 6mm hole. I took off the ignition cover and used the small bolt on the outside to hold the degree wheel. I use a thin spanner wrench to reach the larger bolt behind it to turn the motor.
    1982 GS1000S Katana
    1982 GS1100E

    Comment

    • Anonymous

      #3
      Bolt your degree wheel to a electonic trigger off a GS1150(than you can turn it and watch it without a chance of moving). Dave

      Comment

      Working...