Will an 82 1100 header fit a 77 750?

[77GS750inCincy]

I just picked up a header from a guy off his 82 1100. (kerker, jet-hot coated) cheap and I am hoping that it will fit up w/o MUCH cutting and welding. Any insight is appreciated.

[Tarbash 27]

It will probably fit in the head, pipe & bolt spacing should be the same , but it might hang down lower underneath the bike. Other than that, will probably work fine.

[rapidray]

If you need to cut it up I would like to buy it from you instead. Ray.

[77GS750inCincy]

I am making a rear section using a yosh tri-oval CF can and really only need the header itself. I was thinking of chopping the head pipes and creating some kind of slip fit joint so I can tuck up the collector as tight to the frame as I can get it to maximize ground clearance. thanks for the input

[blowerbike]

did you buy it from a guy near/in hamilton?
this pipe will fit your bike, just have to make a hanger for the collector.
suzuki pipes in general hang kinda low.
gs stuff anyways.

[mullesaurus]

seriously. i'll buy it. if you want to cut one up i'll trade you and vance & hines plus some cash.

[Gilmoses]

I have a V&H sidewinder, that I've had on A 79"gs1000, '82gs750, and a '85gs1150. I dont think the spacing will be a problem on a 77gs750 . . . Heck you have it now, try it out and let us know. . . .

PS. . . Where are all of you Ohio GS folks at when I need help ? ?? LOL

[77GS750inCincy]

blowerbike... i did get it from a guy in hamilton...do you know him? He lived over by tristate

[blowerbike]

77GS750inCincy,
ive talked to him several times about parts and such for his bike.
i seen he had listed the kerker on craigslist a while back.
let me know if you every need any parts or advice/street/drag race info/ whatever pertaining to these bikes.
im loaded up with both and im not real far away.
trenton->--X--<-germantown.
thanks,
terry