My 1327 build

[gearhead13]

falls flat? probly because it is so rich on fuel drowning its self, if it was lean atleast it would wind out

I dropped from a 145 to a 140 main and it winds out to 9k rpm now. I was running 132.5 mains with the 1170. I am trying to decipher the Innovate data graphs to figure out where I am at now. Hard to tell because I don't have rpm or any other data input to tell me when it is at wot. The data logger costs $500

[gearhead13]

Pulled the top end apart to fix a base gasket leak. Did a light hone job and added a 0.010" base gasket to lower compression by ~.5 points (to 10.5-1) as far as I can tell from what I have read:

http://www.johnmaherracing.co.uk/enginecalc.htm

Also degreed the cams 108/108, feels much snappier. Wanted to lower cranking compression for easier starting and not worry about pinging if I have to run 91 gas.
Getting ready to install the RS38 carbs