Hayabusa fork swap on a GS1000

[Guest]

Looking at putting a set of gen 1 hayabusa forks on a 78 gs1000. Anyone ever done this? If so, what all will I need to look into doing? Bearings? Machining the stem?

[Guest]

Allballs has the conversion bearings you'll need. Their site has a coversion table. Stem is fine as is. Steering stops may need some fab work. And keep in mind they are alot shorter than the stock forks.

[RichDesmond]

Also mind the difference (if any) in triple clamp offset. That and the length difference will change the trail, perhaps by a lot. If it is a lot, big affects on steering feel and stability.