79 550E Rebuild
Collapse
X
-
Black wire In hand comes out of Wire harness, not sure where it was supposed to connect too, The starter relay already has a B/W connector, and if I ground this one It wont allow the starter to turn over...
You do not have permission to view this gallery.
This gallery has 1 photos. -
Black with white tracer is ground. Attach loop to solid and clean ground point. Beware of the stock grounding points on that bike; some go to the rubber mounted battery box, or small flimsy brackets. You want a solid point.
Regarding wiring in general, be sure to download the factory manual off Basscliff's site.Ed
To measure is to know.
Mikuni O-ring Kits For Sale...https://www.thegsresources.com/_foru...ts#post1703182
Top Newbie Mistakes thread...http://www.thegsresources.com/_forum...d.php?t=171846
Carb rebuild tutorial...https://gsarchive.bwringer.com/mtsac...d_Tutorial.pdf
KZ750E Rebuild Thread...http://www.thegsresources.com/_forum...0-ResurrectionComment
-
11 years ago my APE pods were half the cost of K&N, every bit as good looking and performing. No other brands that I know of offer acceptable performance. So, negatory on those cheap China pods.1982 GS1100E V&H "SS" exhaust, APE pods, 1150 oil cooler, 140 speedo, 99.3 rear wheel HP, black engine, '83 red
2016 XL883L sigpic Two-tone blue and white. Almost 42 hp! Status: destroyed, now owned by the insurance company. The hole in my memory starts an hour before the accident and ends 24 hours after.Comment
Comment