79 vm26 oring sizes

[mvalenti]

Does anyone know the oring size for the brass fuel T and the fuel rails?

 

[Rich82GS750TZ]

You might find it on cycleorings.com where you can order a complete set of all the orings for you carbs for not much $.

 

[mvalenti]

Thanks Rich, I see they have them in a kit for the BS versions,I have the VM's I was hopingt to get sizing or just buy the orings for the T and Rail.

 

[Rich82GS750TZ]

VM's are #2 on the list at the top of the page. Not sure if he lists the individual sizes.
http://cycleorings.com/
http://cycleorings.com/VMkit.html

for $18.85 for the whole set, you can get them all.

 

[chuck hahn]

I would get the full kit and replace all of them since carbs are off. Pop off a intake manifold and measure the ID of the prongs for those too. Intake stuff is on page 3 of the website

 

[mvalenti]

Thanks, I replaced the orings in the carbs last year, I bought the set from him a while back. Hoewver I do not recall they came with the fuel T orings.

 

[Nessism]

1.9mm x 7.8mm should work.

The OD of the O-ring groove is 8.17mm and the ID of the hole in the carb is 11.0mm

 

[mvalenti]

much appreciated

 

[hannibal]

In case you can locate the kit you bought, Cycle O Rings includes the fuel rail O rings with the carb O ring kit. If not, maybe he'll sell you them separately.