• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

bs 32 ss cv carbs on 650!

  • Thread starter Thread starter tconroy
  • Start date Start date
T

tconroy

Guest
I put a new 5/16ths fuel line on but it seems to have caused problems. It seem to vapor lock the petcock.When I take my tank off and put it back on I have to drain a carb bowl to get the fuel to flow in the prime position. THe bike runs fine but will not idle well.Even sitting at a light it will go up and down from 100o to 15oo.If i ride hard and stop fast it will almost die before returning to idle.It never did this with the 1/4" fuel line.Why would the bigger line be different or is there another problem I might have?When I got back from riding to work today the fuel line was half empty and the prime would not work till i squeezed the fuel line like a primer bulb on a lawn mower.Bike bandit says the line is 6 by 10 by 16. Can anyone convert this for me or tell my which is closer to that size, 1/4 or 5/16ths. Also when I hooked up my long 5/16ths fuel line to sync the carbs it would not flow unless i unhooked it from the carbs and opened the end of the fuel line.Any ideas????Help please!!
 
Try this. Remove the gas line from the valve and attach another off to the side. Remove the vacuum line from the carb. With your valve on suck on the vacuum line, if you get gas your valve is good, maybe your fuel line is too small. My bet is your valve is not opening properly or your have a air leak.
Start the motor and spray a little WD30 around the intake boots and air box boots. If the motor speeds up, you have a leak. Do you have an in line filter? If so that may be your obstruction.
You may need a carb cleaning and sync.
Gustov
 
Fuel line could be too long- Do you have a filter ? get ride of it if you do!
Check the gas cap vent!
 
The fuel line does not appear to be at fault here.

Most of your symptoms could be easily explained by a vacuum leak. Do the WD-40 test, or ether, or whatever around the carb boots.

If THAT is not it, something else is causing you to run lean. Have you cleaned your pilot screws lately? Ever? This is exactly how my bike ran before I cleaned those.

Your petcock may not be working properly on prime, but that is not the problem you're describing when you get the bike running. :-) A petcock rebuild kit is in order, but not vital.
 
Thanks for all the posts guys but i found the problem. BAD GAS!!!! i drained my tank and bowls then cut off about an inch of fuel line.Then i filled the bowls and fuel line with spray seafoam followed by seafoam liquid in the fresh gas I put in.After that i fired it up and took off for a good ride.After hauling @#@ for a while I came to a quick stop which before would bring my idle down to 500 before going back up to 1100. It idiled at 1100 and did not drop!It idles smoothly now and the rpm's stay dead on the mark.I got gas at a Q T in a small town by my work not where I usually get it,at conoco.The QT pump was slow and did not have a gas smell to it.I did not pay much attention to these signs as far as being a problem but i guess gas is not the same whever you buy it.Anyway it runs and idles perfect now and that's all that matter's.Thanks again for all your help and concerns.The GS resources and the people on here ROCK!!!! Oh and nebro I have all new boots and o-rings and all the other goodies that you have to do to an old bike when you buy it Plus the petcock works fine now that i cut off about an inch of it.I guess it was too long.Thanks squaredancer lynn.
 
Last edited:
Bad gas would give you the exact same reaction as leaky carb boots :-) Water != fuel. Less fuell = lean. ;-)

Gotta love multiple causes for the same problem. I've only run into one occaiton where bad fuel was the problem.
 
Bad gas would give you the exact same reaction as leaky carb boots :-) Water != fuel. Less fuell = lean. ;-)

Gotta love multiple causes for the same problem. I've only run into one occaiton where bad fuel was the problem.
My bike always ran great that's why I thought the worst.All I can say is pick a gas station and stick with it.I have gotten gas at 2 stations in that area and both times it has given me problems.
 
Back
Top