Required reading for all forum users!!!
Welcome!
Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.
A note to new registrants...
All new forum registrations must be activated via email before you have full access to the forum.
A Special Note about Email accounts!
DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.
A note to old forum members...
I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.
Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.
Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...
If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.
If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.
I would have done the stem swap but I had already bought all the nuts and stuff to bolt on the Honda triple when I found out the stock bearing didn't fit the 954 stem. I was either going to have to have the neck milled to fit the 954 bearing or make the stock bearing fit. It worked out well and thanks to you with your tip on the 954 triples the bike is back close to its original geometry.
Most of my mates go for GSXR1100 front ends due the fork length being about right with a standard rear suspension on a GSX or Katana.
I've used hayabusa forks successfully with a 954 top yoke (can't say if busa stem fits as I had to make one). My Kat has been lowered by using SRAD forks and a three piece bearing to accommodate the SRAD stem.
