G
gs1100ez
Guest
when i changed my rr i did a lot of reading
i'm not one who likes to hack into stuff if i can, i always like to leave the factory stuff just incase
so i mounted a relay right by the coils themselves
i ran a new 12v+ from the battery to the 30 pin
the 86 was wired to a ground -
87 was then sent to the coils +
and 84 was the signal from the stock wiring that went to coil +
this way the stock harness wiring basically tells the relay to power the coils
very easy
simple
clean
out of the way, stays dry
and easy to swap back if for some reason the relay dies on a ride without having to take the tank or side covers off
works great
bike starts very fast
i'm not one who likes to hack into stuff if i can, i always like to leave the factory stuff just incase
so i mounted a relay right by the coils themselves
i ran a new 12v+ from the battery to the 30 pin
the 86 was wired to a ground -
87 was then sent to the coils +
and 84 was the signal from the stock wiring that went to coil +
this way the stock harness wiring basically tells the relay to power the coils
very easy
simple
clean
out of the way, stays dry
and easy to swap back if for some reason the relay dies on a ride without having to take the tank or side covers off
works great
bike starts very fast