The 41 year old PCB for the horn switch is bent and no longer making contact. I bought an aftermarket switch and plan to wire it in.
Wiring diagram shows G and B/W coming from the switch.
My plan is to snip the factory wires, snip off the switch's aftermarket connectors, then connect the wires from the switch to the factory wires heading into the harness using spade or bullet connectors. I assume it doesn't matter which switch wires attach to the G and B/W from the factory harness. It's just a normally open switch that closes the circuit when the button is pressed.
Is it really that simple or am I missing something?
Pic for reference
Wiring diagram shows G and B/W coming from the switch.
My plan is to snip the factory wires, snip off the switch's aftermarket connectors, then connect the wires from the switch to the factory wires heading into the harness using spade or bullet connectors. I assume it doesn't matter which switch wires attach to the G and B/W from the factory harness. It's just a normally open switch that closes the circuit when the button is pressed.
Is it really that simple or am I missing something?
Pic for reference
Last edited:
