Float adjust/Fuel leak

[jeremy44]

I have a pretty good amount of gas leaking from the purge tubes from my carbs, and even a little out of the airbox when the tank was still full on the 77gs750 i just picked up. When resetting the float height should i be measuring from the recess where the bowl sits or from the bottom edge of the carb to the top of the float? I wasn't quite sure from looking at the service manual
http://www.mtsac.edu/~cliff/storage/gs/GS750_Service_Manual_early8valve.pdf

Is there anything else that could be causing this besides an improper float adjustment? The bottoms of my carbs are dry, and i don't think my carbs have a gasket where the bowl sits on the carb if that matters.

 

[tkent02]

What's a purge tube?

 

[jeremy44]

I don't know what its called otherwise, the tube that dumps the extra fuel onto the ground when the bowl starts to overflow

 

[tkent02]

Measure from the gasket surface, sans gasket, to the bottom of the float.

 

[BassCliff]

Hi,

I found this on some guy's website:

Float Height Illustrations


Thank you for your indulgence,

BassCliff