• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

GN125 sliders to GSX 400F one problem

  • Thread starter Thread starter Himer
  • Start date Start date
H

Himer

Guest
Hello again,

I am almost finished with my carbies I am only in need of new slider assemblies because diaphragms are in holes to be exact three of them are bad. Replacement diaphragms are in need to be glued I don't trust that plus my sliders are worn also.

This is polish but as you can see: http://allegro.pl/membrana-gaznika-przepustnica-suzuki-gn-125-24-mm-i6801935883.html

GN125 slider has 3 airports in it my sliders have only one. Does it make a diffrence or I need to somehow plug those additional holes and swap needle plate for the blind one from my sliders?

I just don't know how to correctly plug those additional passages only question I have. So far I have only one solution I have german RTV which is completely immune to gasoline(it won't break) so I can clog those holes with it.

Any other ideas?

I really would like to have NOS new sliders, but those are gone from this world I can only depend and what China makes today.
 
Those look good.. why not try them leaving the 3 holes undisturbed... it might not matter as the idea is to get good vacuum over the diaphragm top.
 
The extra holes might cause the slide to lift faster than the engine wants. In the past where I've drilled the slides to tune them to an engine - but gone too big - I've made up lightweight plastic plugs and epoxied them in place. No failures yet...
 
So far with my polish friends we also deducted to have some type of plug and then fill it with epoxy and we have "poxipol" there it will do the job. I am going to clog those ports and then use blind plate. I think this motorcycle will finally go to a good state i guess. Thank you.

Only a shame those sliders are indeed chineese :/ but nothing more is to buy my only option to get this bike running for at least couple of thousands :/
 
You must log in or register to reply here.
Back
Top