GS550 Rebuild Engine questions

[Guest]

Use one of these and lots of WD-40
Around 30 seconds in each cylinder with a slow but consistant up and down motion.

 

[jakeolsen]

You want to play russian roulette with your engine with cheap gaskets and put it back together with worn out rings that your perogative.
I *thought* you said in your first post that you wanted to do it right.
Why did you tear apart the engine in the first place? was it leaking or burning oil?

Please read ALL of my posts before jumping on me. I am obviously on here asking questions so that I can do it right. If those gaskets are junk, nothing I have seen has stated that, so how am I supposed to know?

I never said that I don't want to replace the rings either. I said that I don't want to replace them IF they are still plenty good. It would only make sense since I am on a budget to spend the money where it is needed and NOT where it isn't.

If I find that they are even close to worn out, they will definitely get replaced, as is everything else on this bike that is at or near its end (fork springs and seals, rear shocks, exhaust gaskets, intake boots and gaskets, ignition coils and wires, the list goes on..).

I am totally new to the restoration process, so please give me the benefit of the doubt. I am trying to ask as many questions as possible so that I can avoid mistakes like not replacing things that need to be. With that said, I will not be bullied into doing anything on my bike. I am asking for CONSTRUCTIVE criticism, not out and out criticism just for criticising sake.

 

[jakeolsen]

Use one of these and lots of WD-40
Around 30 seconds in each cylinder with a slow but consistant up and down motion.

Thanks! What is that thing called?

 

[Guest]

Thanks! What is that thing called?

A "ball hone"