S
Showdown
Guest
It worked!!!
It worked!!!
:clap:
A special thanks to:
mpencegs - for helping with the "fuel screw" 2 turns out ("idle mixture adjustment screw" ha ha)
pete - for helping with the float level 26.6 +/- 1mm
-AND-
for saving the freakin' day by catching my signal generator rotor being 180 degrees out!!!
and I'm very grateful for mekanix's support and interest in helping me get this bike started! (and for scaring the crap out of me that my cam timing was WAY off! lol)
I took her outside after rebuilding the carbs, temporarily installing the gasket-less valve cover, and buttoning everything else up... she fired on the first crank and got to ~4k RPM with choke on.
I have new boots, float bowl gaskets, and valve cover gasket on the way... I'll check the valves as well.
Thanks again for helping me get this thing started! I'm the third owner to try and get it fixed!
*Oh, and who can forget Steve with the terminology lesson and the spreadsheet... thank you!
It worked!!!
:clap:
A special thanks to:
mpencegs - for helping with the "fuel screw" 2 turns out ("idle mixture adjustment screw" ha ha)
pete - for helping with the float level 26.6 +/- 1mm
-AND-
for saving the freakin' day by catching my signal generator rotor being 180 degrees out!!!
and I'm very grateful for mekanix's support and interest in helping me get this bike started! (and for scaring the crap out of me that my cam timing was WAY off! lol)
I took her outside after rebuilding the carbs, temporarily installing the gasket-less valve cover, and buttoning everything else up... she fired on the first crank and got to ~4k RPM with choke on.
I have new boots, float bowl gaskets, and valve cover gasket on the way... I'll check the valves as well.
Thanks again for helping me get this thing started! I'm the third owner to try and get it fixed!
*Oh, and who can forget Steve with the terminology lesson and the spreadsheet... thank you!
Last edited: