A
aedi006
Guest
So I just took off, cleaned, and bench synced my carbs ('82 GS850GL), which was my first rebuild/clean ever. I just went to re-install the carb and I am at a loss to which hose goes where. The clymer manual was no help. Using the Carb-cleaning pdf from the GSResources here are my hoses:
2 x "Vent T"
1 x "Fuel Inlet"
1 x "Vacuum Port"
I would assume the fuel inlet goes to the large fitting on the petcock.
I think the vacuum port goes to the small fitting on the petcock.
There is a large tube coming from the top of the engine which is not connected to anything now (maybe the Vent T goes here, but there are 2 Vent Ts). Any help is greatly appreciated.
2 x "Vent T"
1 x "Fuel Inlet"
1 x "Vacuum Port"
I would assume the fuel inlet goes to the large fitting on the petcock.
I think the vacuum port goes to the small fitting on the petcock.
There is a large tube coming from the top of the engine which is not connected to anything now (maybe the Vent T goes here, but there are 2 Vent Ts). Any help is greatly appreciated.