P
pfallone
Guest
Ok, so i just purchased a 1979 1000E and it sat around a neighbors garage since 1989 and it started right up!!! Put about 100 miles on it, then i had some problems. No spark. I am highly versed in electrical, so i went to the task of finding out my issue. First, i check wiring near the battery, and multiple wire connectors have melted heatshinks(high resistance/excessive current flow?) checked power to coil. B+ to orange wires with white tracer to coil B+. B+ to yellow wires at breaker points. Clean black and grey wires from points to coil. (.3 ohm) ..now i have an open from the 1-4 plug wire and 2-3 plug wire(checking resistance of coil). and when i disconnect the breaker point signal wire i get b+ at the coil side(short to voltage) on both the black and grey wire. killsiitch and ign switch are working properly. any ideas? (NO blown fuses)
Last edited: