T
trmcgrade
Guest
Howdy everyone. I recently bought a 1982 GS650GLX that had been badly abused because it was cheap, and it seemed like a good starting place because of the engine. I wanted to ride a sweet bike, but not shell out the money for one new, or even one that had been maintained, and figured a project could be fun, so here I am! I've already taken care of the carbs (new o-rings, rejetted, cleaned thoroughly), the intake (new boots and o-rings. No need to seal the airbox because it came to me with pods), fixed the valve clearances and replaced the valve cover gasket, and purchased a new stator and reg/rec. So, I think I've gotten most of the basics taken care of, but cut out the wiring harness from the PO because it was mangy and in bad shape, and now need to build a new wiring harness so I can get this thing back on the road and enjoy it. I'll be posting shortly over in the electrical section with some questions about that, if anyone is inclined towards helping me in that arena.
For now, I'll leave a picture of the bike as I got it here, with a guarantee of a new (and hopefully more enticing) photo when I get it all done.

This forum has already been a wealth of knowledge and I'm looking forward to returning this guy to its former glory.
For now, I'll leave a picture of the bike as I got it here, with a guarantee of a new (and hopefully more enticing) photo when I get it all done.

This forum has already been a wealth of knowledge and I'm looking forward to returning this guy to its former glory.