• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

regulator/rectifier issues? turn signal gets stuck on...

  • Thread starter Thread starter snowbeard
  • Start date Start date
S

snowbeard

Guest
so when I'm at a light and turn on the signal (so far only noticed this on the left) it blinks for a couple, then starts slowing down, then gets to the point that it can't store enough juice to kick over/off and just sort of bogs down the electrical. (the headlight dims as the blinker goes on either way) If I don't do anything it will slow down the engine as well, but if I just rev it real quick, it gets back on track and flashes again, but starts the bog process over...

would this sound like a reg/rect problem, or all the way to the alt?? I have a multimeter around somewhere, but at the moment can't seem to find it :evil:

thanks for any thoughts!!!


OK, so I've been reading the my regulator mod threads, and wondering if a RR from a bigger bike is going to be just as good? wouldn't it just have to work less hard to regulate or would it be too strong and over regulate... I guess it's only in how fast the alternator spins that makes the biggest difference???
 
check the tips section for reg modification The Honda reg will work on any GS bike if funds are short. I would CHECK the stator output first, make sure it is healthy then check the reg/rect. In 1980 when they went to elect ign the stator output was increased 30%
 
Two things you said makes me think you need to find your meter.
Yep, Blinker will go slower at lower voltage. When you rev engine the chrging system puts out more and raises the voltage so the blinker runs better. But charging system should put out enough to have good enough voltage to run blinkers even at lower rpms.
Headlight dimming when blinkers blink also indicates real low voltage.
Sounds like your charging system isnt putting out much, so the voltage is low especailly at low rpm.
Need to find your meter to verify this. And will also need meter to troubleshoot the stator and/or regulator-rectifyer like Lynn said.
Or maybe check to see if the connections between the stator and the R/R are getting hot, bad connections (that was my problem) dont need meter for that.
 
U need a few things.

U need a few things.

The multi meeter is a must.... Also you need a hydrometer to tell you if the battery is any good. If you don't start with a good battery that is fully charged you won't know what the system is doing.

Check and clean any connections before you get started as well.
 
Same thing happened to me, except I had the problem on equally on right and left sides. The stator papers helped me diagnose a faulty r/r, which I have since replaced with a Honda unit from Ebay. I can't say whether the problem is fixed because a flat tire and a move to another state have prevented me from riding the bike since then. But this weekend I will know for sure.

Short of finding your multimeter and troubleshooting with the stator papers you might want to clean the left side connections and check for burnt out bulbs. I found my turn signal switch was very corroded when I opened it up.

For what it's worth here's the thread on my electrical problems

http://www.thegsresources.com/_forum/viewtopic.php?t=25181&highlight=
 
The electrical system must be checked entirely, but you absolutely must check the battery first, and check the ground leads. Even add another ground to the frame.


Note that once you have determined that there is a viable output from the stator, and it is getting to and through the R/R, the quality of electrical connections is paramount. They tend to corrode over time, and exposure, and must be cleaned.

When clean, use a small dab of dielectric grease to ensure a long-lasting connection.
 
Hi, before you go into the electronics, check your battery. Even if you have sufficient juice to start it, the battery can be low enough not to provide enough oomph at idle for all the bikes needs. I had a similar problem with my bike, the turn signals would not blink, or if was lucky, blink very slowly. Problem went away after I put in a new battery.

Good luck!
 
hmmm. the battery is only a year old, tho I did nothing special to it over the winter. I found my meter, and next time I get a second I'll see how it looks, battery and all!

thanks everybody!!
 
snowbeard, did you see my reply in this thread about your email? I cannot send you the invite without it :) I wasn't ignoring you. I am waiting for your reply buddy. :)

I know this was off topic, just wanted to catch you.
 
I would clean all the electrical connections. Then, clean all the electrical connections. Don't forget to clean all the electrical connections. Did I mention clean all the electrical connections? Oh yea, then run a ground from the R/R to battery (-), then test it. Get the grease also.
 
You must log in or register to reply here.
Back
Top