Replacing turn signals with seperate led mirrors on an 1981 gs850l

[jonny_lunchbox]

Hi, I want to install some mirrors with built in led singnals. It comes with wiring to wire into the existing turn signal wiring. I did a lot of searching and didnt find the answers i was looking for. What all do I need to make this work? I did purchase some 12v led resistors to wire in between the mirrors and original wiring. Would this solid state box that i am reading about have any benefit for this? thanks for the help.

 

[almarconi]

I have a set of turn signal mirrors on my truck. They are wired in to my existing turn signal wiring using a wire taps. I would leave your existing turn signals on the bike and wire the mirrors into the existing wiring. I don't have a wiring diagram for your bike but more than likely the wires you need to
tap into are in the headlight bucket.

 

[Steve]

Those mirrors are likely set up to connect directly to the 12-volt system on the bike, no resistors necessary.

Yeah, keep your stock signals. The signals in a the mirrors are likely not DOT approved. If your state has vehicle inspections and those are your only signals, the bike won't pass.

.