This has happenned to me at least twice now. When I get to about 70 miles on a tank of gas it starts acting like it is starving for fuel. (I normally get about 105 before I have to put it to reserve) First time it happenned I limped it home and took the car to work. Next day I went out and put it on prime and it started up. Felt better. Moved petcock to normal position. Filled up the tank and it was fine.
Yesterday morning it happenned again. About 71 miles on the tank and it acts like I am reserve level. Stopped by and filled up but it still felt like it was starving for fuel and running rough. Drove car again to work.
Tonight I get home from work and go out to start bike. Put it on and listened to it flow for a few seconds. Pulled up on choke. Started up great. Then about 8 seconds later it was running rough again and now I can't get it running right.
I pulled off the fuel line, hooked up extra line and the petcock is operating properly. Flowed into a container freely on prime and properly on normal position when I sucked on the vacuum line.
I checked spark on all four wires with an extra plug.
I dropped the float bowl on number one and it looks clean. These carbs were fully taken apart and rebuilt about a year ago. Orings etc.
Not sure what to check next.
I did rebuild the petcock about 5 tankfuls ago.
I ride this bike about 4 times a week to work.
I also checked the gas cap thinking maybe it wasn't venting properly. Blew some cleaner through the holes and it flowed okay. Then I blew it out with air.
Any suggestions?:-k
Thanks.
Yesterday morning it happenned again. About 71 miles on the tank and it acts like I am reserve level. Stopped by and filled up but it still felt like it was starving for fuel and running rough. Drove car again to work.
Tonight I get home from work and go out to start bike. Put it on and listened to it flow for a few seconds. Pulled up on choke. Started up great. Then about 8 seconds later it was running rough again and now I can't get it running right.
I pulled off the fuel line, hooked up extra line and the petcock is operating properly. Flowed into a container freely on prime and properly on normal position when I sucked on the vacuum line.
I checked spark on all four wires with an extra plug.
I dropped the float bowl on number one and it looks clean. These carbs were fully taken apart and rebuilt about a year ago. Orings etc.
Not sure what to check next.
I did rebuild the petcock about 5 tankfuls ago.
I ride this bike about 4 times a week to work.
I also checked the gas cap thinking maybe it wasn't venting properly. Blew some cleaner through the holes and it flowed okay. Then I blew it out with air.
Any suggestions?:-k
Thanks.