Post a picture of your custom GS

[russr33]

My '78 GS100 - pics are about a week old, finished up a few things since then, changed a couple things - got to ride all weekend, so the work progress slowed down some, but the ride was good for the soul!

That is one sweet ride. Very nice sir

[Big_T112]

85 1150 Turbo

1985 GS1150ES Turbo. 1395cc bigblock, web cams, Ward head, Falicon crank and rods, Strait cut gear with billet basket, race cut trans. with billet 2nd and 3rd gear, MTC lockup. Streched 4 inches, swingarm widened, Stock rear wheel widened to take a 190/55 tire. Dyna 2000 ignition with boost activated timimig retard, Airshifter, A blast from the past,

[Guest]

big_T how do you widen a stock wheel?

[Big_T112]

wheel

You send it to Kosman and he machines the stock sides down and then welds new wider sides back on. I am saying this because with the tire off you can see from the inside where it has had the new piece added on each side of the rim. turns it into a 6" inch wide rim that will now hold a 190/55-17" modern tire. The previous owner did the wheel. I am sure it was not cheap. I am going to put the GSXR wheels and brakes I have on it and take these in the picture off.

[KiwiGS]

I can see the light at the end of the tunnel, on this project.

Cheers

[Dogma]

Lookin' good. Did you knit a red master cylinder cozy?

[Richharr]

Lookin' good. Did you knit a red master cylinder cozy?

wrist band,

[Guest]

I can see the light at the end of the tunnel, on this project.

Looks good!

Does it run good? (perfect)

[KiwiGS]

Lookin' good. Did you knit a red master cylinder cozy?

Thanks, the cozy came with a bike mag so you know it's cool

Looks good!

Does it run good? (perfect)

Thanks, I have not run it since I set the tappet clearances.
It ran good before, so it should be better

[Hector Penalosa]

1980 Suzuki GS 1100E

[Hector Penalosa]

1980 Suzuki GS 1100E

[Hector Penalosa]

More

[Guest]

Very very nice, mr Hector

[se7enine]

Does anybody have anymore specs on these bikes?

[L3X1V0R3]

Rat-ish mod in progress...here is the current state. So far it's just a lot of paint and black duct tape. I'm in Wisconsin so I'll have all winter to work on the big mods. With a little work this should have a lowered back end and a solo seat by spring as well as some nifty knobby tires covering up the chrome on the fenders. After that It's probably gonna be a collection bike of sorts. Lots of keys and baby doll heads, skulls and other bits of dead animals, cargo nets...you know the sort.