Hey Guys,
Full disclosure: I own and run a motorcycle repair and engine machine shop. I have an engine I am building for a 1982 GS1100G (8-valve,...
49 results in 0.0065 seconds.
-
Sourcing GS1100G Engine Parts - Mostly Gaskets
-
Help! Carburetor/fuel mixture problem (I think) 1979 GS1000
Hello all,
This is my first post here and I hope to gain some knowledge from you folks that probably know quite a bit more than I do.... -
GS1000EC '79 air box boots (tube / outlet) change problem.
Guys,
during my restoration of Suzuki GS1000EC from 1979 I have encountered following problem, namely diagnosis showed that it is necessary (due... -
1980 gs1000g starter clutch
Hi all,
Been chasing a new starter clutch for a 1980 GS1000G for 6mths with no luck, has anyone had any success repairing a crack like this?... -
GS1000 8 valve with 3000 rpm problem
Suzuki
Gs1000
60785km
Cylinder revision 0.5, new timing chain and exhaust guides
Carbs 6/19/2019 Cleaned Ultrasonic and fitted...Last edited by Guest; 07-12-2020, 11:21 AM. -
1978 GS1000 wont rev over 4000 rpm under load
I recently purchased a 78 gs1000 and it revs to 8k rpm no problem at idle and sounds beautiful but when you get to riding it it loses power/bogs/sputter... -
1979 GS1000E Engine vibration with rpm
Hello everyone I am new here. I have fairly good mechanical knowledge just not allot of experience with this bike and am looking to learn everything that... -
Chopped up GS1000 - Attempting to resurrect it
So to make a long story short, around 5-6 years ago I was young and reckless with money and I bought a chopped up and modded GS1000 with a rebuilt engine,... -
Starter Troubleshooting - 79 GS1000
I put the key in, turn on ignition, lights all come on. Horn will meekly beep a time or two, but then acts like the batter has died, though it's a new... -
-
Dark at High RPM
I recently finished rewiring my '79 GS1000L and everything seems to work fine, until I get the engine above about 6,000 RPM at which point the gauge cluster... -
GS1000 newbie in SLC
Hi everyone,
I am thrilled to see the treasure trove of info and wisdom here. I'm currently working on a 1979 GS1000:
... -
New GS1000G owner
Picked up my new GS last Saturday, now just getting it ready for the German TUV. Here's a small picture of it, its got a Motad exhaust and a long range... -
1980 gs1000 stumbles at 4.5k RPM
Hello all at GSR, I'm currently having difficulties with my bike. 1980 gs1000, revs to 10+k in neutral or with the clutch in, but coughs out at 4.5k RPM... -
Hello from Texas.
You guys were very helpful in identifying my bike a couple of months ago seen here:
http://imgur.com/a/s1Aqx
We got it running to confirm...
