1000SZ master cylinder rebuild order

[first timer]

it's been to many year since i pull this thing apart, now is time to rebuild. I let the old seal pack assemble the way it came out the best i can rember but can you folks confirm a few things?
@Nessism​
@bwringer​
first picture, is this the order in which in all get stuffed into the cylinder?

second question

the shaft, seal does it get pressed into the metal cup like shown in the old set?
is the shaft seal turned in the right direction?

 

[Nessism]

I'm sorry, I don't know the answer. Other than, it seems that the seal does press into metal cup, assuming there is a recess to do so.

I'd try to replicate the old setup, if possible. It's been working for a long time, eh? That suggests it's okay.

 

[first timer]

thanks for the input it kinda confirms what i am thinking.
i'll dig through my parts stash and see if i have any other MC i can pull a part.

This is the best image i could find in the manual


page 10-24 of the 1100 manual​

 

[first timer]

so i put it together like the "new set" photo shows. I stuffed the gasket into the cup like the "old set" shows. It's building pressure and not leaking so i would assume i have done it correct. Lets see what 24hr says.

I pull a early model MC a part and confirmed seal edge direction, even though it's a different design the leading seal edge direction is the same.

here is a pic of the progress

​

 

[bwringer]

Niiiiiiice!


I took this a while back as a reminder to future me of what goes where in what direction in general.

Maybe it will be of some use to someone somewhere.