• Required reading for all forum users!!!

    Welcome!
    Register to access the full functionality of the GSResources forum. Until you register and activate your account you will not have full forum access, nor will you be able to post or reply to messages.

    A note to new registrants...
    All new forum registrations must be activated via email before you have full access to the forum.

    A Special Note about Email accounts!
    DO NOT SIGN UP USING hotmail, outlook, gmx, sbcglobal, att, bellsouth or email.com. They delete our forum signup emails.

    A note to old forum members...
    I receive numerous requests from people who can no longer log in because their accounts were deleted. As mentioned in the forum FAQ, user accounts are deleted if you haven't logged in for the past 6 months. If you can't log in, then create a new forum account. If you don't get an error message, then check your email account for an activation message. If you get a message stating that the email address is already in use, then your account still exists so follow the instructions in the forum FAQ for resetting your password.

    Have you forgotten your password or have a new email address? Then read the forum FAQ for details on how to reset it.

    Any email requests for "can't log in anymore" problems or "lost my password" problems will be deleted. Read the forum FAQ and follow the instructions there - that's what we have one for...

  • Returning Visitors

    If you are a returning visitor who never received your confirmation email, then odds are your email provider is blockinig emails from our server. The only thing that can be done to get around this is you will have to try creating another forum account using an email address from another domain.

    If you are a returning visitor to the forum and can't log in using your old forum name and password but used to be able to then chances are your account is deleted. Purges of the databases are done regularly. You will have to create a new forum account and you should be all set.

Carb Setup, 1100EZ, Pipe and Pods

  • Thread starter Thread starter Turtleface
  • Start date Start date
Some Progress...

Some Progress...

Alright. Small successes, so far. My parts showed up mid-week, and I finally found the time to work on the bike today. Installed the correct set of pilot jets, (45s, I'll install the 47.5s after I get through emissions) and voila! She started right up, and immediately idled dead smooth at about 1050-1100 rpm. Needed about 1/4 choke for about half a minute, then idled fine on her own. She catches and starts running on about the 2nd or 3rd rotation, it's nearly instant. Air temperature is about 103 degrees today. Bike was dead cold. I have the DJ 138s in, but did not install the optional air-jets that came with the kit. Mixture screws are 2.5 turns out. Still need to sync the carbs, but I'm not terribly far off, according to my Carbtune Pro. Throttle response is smooth (no load, bike on centerstand), with no obvious bogs or sputters throughout the RPM range. There is very little hesitation, even when opening the throttle quickly. The engine comes down from high RPMs at the same speed as it goes up through the revs, there are no symptoms of intake side air leaks. However, the knocking sound that I originally took the bike off the road for is still present. Nuts.
 
Last edited:
Back
Top